If the battery is not low and the connections are good, load test the battery. Inspect the cable to make sure it is not damaged. If it is off, it is possible that you lost power at the outlet, the transformer is blown, or something is wrong with the wire from the transformer to the circuit board. If you have already programmed a single button remote and the ninth dip switch is set to a (-), then use the dual button remote and begin programming following the instructions beginning at the first step. $15 Off Mighty Mule Input Power Disconnected Coupon on Orders Above $45. If the arm works, you may have a problem with the slave arm. Turn the fuse over on its flat side. For two years this worked great and met our needs. However, if the issue persists, then you might be dealing with a defective motor. Toll-free: 1-800-869-2922 Installing automatic electric gates is not that easy. Under normal conditions, it may be noted that the operator arms for the MM560/562 take longer to open than the MM1000 or PRO 1000. There might be something stuck in them too. There is no 120V power source at the gate, only a deep cycle marine battery. (956) 983-6121, 2017 Brownsville Public Utilities Board. If the transformer and the battery are good, check the charging circuit with the battery and transformer connected to the board. After pursuing the app, I noticed a power setting set to low on the gate . Under normal conditions, it may be noted that the operator arms for the MM560/562 take longer to open than the MM1000 or PRO 1000. If the gates are not closing with the automatic timer, then going through the configurations is the way to go. Make sure to look at the loop detectors when you turn the motor on. The problems with the blown-fuse might not seem that serious, but they can sure be annoying. Toll Free (800) 543-1236; Monday - Friday 8am - 7pm EST; Saturday 10am - 6:30pm EST; Visit Online Support; Products. Then you should check for the key switch. Check the condition of the PWR IN light on the left side of the circuit board. The Mighty Mule Smart Control Door/Gate App controls: - Up to 10 users per Door/Gate. Make sure that the wires are on the correct terminals and making good contact. Power Input: Used to connect power supply (8-24 Vac/dc) when using outside power source. Email:[emailprotected], Public Utilities Board Consumer Advisory Panel (PUBCAP), Electric or Water Emergency? Accessory Type: Batteries/Rechargers. If the gates are not closing with the automatic timer, How To Effectively Change Roborock Dock Location? Mighty Mule | Northern Tool So, you've likely messed up the installation, and the unit is not installed correctly. The corrosion might have gotten to it or if it might be damaged in some other way. Release the transmitters button and the beeps will stop. Any advice at all would be helpful as this unit has been nothing but a headache since purchase. Mighty Mule is the best buy in its class. This process may take 8-10 seconds. All Rights Reserved. Compare them to other utilities across the state. 1998 - 2023 Nexstar Media Inc. | All Rights Reserved. Normal operation when remote or wireless keypad is used. If the master arm works when connected to the master cable terminals but the slave arm does not work connected to the master cable terminals, the problem is with the slave arm. One reason might be the antenna which was cut or just shortened. This will allow the gates to open and close at the same time without a delay. Utility rates were raised and collected over several years to raise funds for BPUBs ownership share. Mighty Mule Wireless Digital Keypad (FM137) $57.83. You can connect the motor wires directly to the battery to see if it will work.
Christopher Nelson Obituary 2021,
Shepherds Hut Cornwall Airbnb,
Articles M